● Plugs into
110v or
220v
● Installation less
than
30 min. |
The Standard Spa and Turbo systems consist of only two
components, an electrical control box that plugs into a standard
110V or 220V outlet and a clear PVC chamber that is installed in
the return line to your pool or spa from the filter or pump.
The system can easily be installed in less than 30 minutes. The
only work involved is cutting a small section of the PVC pipe
out of the line that runs back to your pool or spa and gluing
two fitting on the ends of the pipe that was cut. The chamber is
then screwed hand tight onto the fittings. |
 |
The ionization/oxidation chamber in
spas is installed in the water line used by the recycling pump.
The controller is wired to the spa electrical service panel that
is available for an ozonator. If the ECOsmarte System is being
used to replace an ozonator, the system can be wired using the
plug attached to the ozonator.
|
